Microlife Thermometer veterinary 1831 1 Piece

Microlife Thermometer veterinary 1831

This thermometer is only suitable for measuring animal body temperature.
• The minimum measuring time until the signal goes off (beep) must always be maintained.
• Protect the thermometer from damage caused by dropping or hitting.
• Avoid ambient temperatures above 60°C. Never boil the thermometer!
• Use only the common cleaning agents listed in the chapter "Cleaning and disinfecting" to clean the thermometer. The thermometer must be in good condition when
he is being cleaned.
• The manufacturer recommends having the accuracy checked by an accredited laboratory every 2 years
- 10 seconds temperature measurement
- Automatic self-test & switch-off
- 100% waterproof
- Digital JUMBO LCD
- Memory of last measurement

What is this medicine used for?
Measuring the body temperature of animals.

Directions for use
To turn the thermometer on, press the button: a short beep will indicate "thermometer on." A display test will be performed. All options will be displayed. If the ambient temperature is below 32°C, "-- -" and a flashing "°C" will appear in the upper right corner. The thermometer
is now ready for use/

During a measurement, the measured temperature is displayed continuously. The "°C" indicator flashes during this period. When the signal sounds (10 beeps) and the "°C" indicator stops flashing, this means that the measured temperature increase is less than 0.1°C per 8 seconds and that the thermometer is now read
can be.
To save battery life, gently press the off button to turn the thermometer off. Otherwise, the thermometer will turn itself off after about 10 minutes.

If the button is held down for more than 3 seconds when the thermometer is turned on, the automatically saved maximum temperature of the last measurement will be displayed. At the same time, an "M" for memory will appear in the display window.
Approximately 3 seconds after releasing the button, the temperature value disappears and the thermometer is ready to take a measurement.

Measuring method
In the anus (rectal)
Carefully insert the thermometer's measuring sensor
2 to 3 cm in the anal opening.
Measuring time approx.: 10 seconds.

The thermometer is 100% waterproof and can be completely submerged in water or
in disinfectant solutions. Then dry the thermometer with a damp cloth. Use one of the following disinfectant solutions for disinfection, following the manufacturer's instructions.
Isopropyl alcohol 70% - immerse for a maximum of 24 hours

Replace battery
When the "▼" symbol (upside-down triangle) appears in the display panel, the battery is empty and must be replaced. To replace the battery, remove the battery compartment cover from the thermometer. Insert a new battery with the + side facing up.
Make sure you have a battery of the same type on hand. Batteries can be purchased at any electrical store. For battery disposal, see "Important Safety Instructions."

Ingredients
Thermometer with protective cover

Warnings
For use on animals only.

Other information
Medical device. Read the instructions for use before use.

Manufacturer / Distributor
Microlife AG, Espenstrasse 139, 9443 Widnau , Switzerland