HG Plastic Protector 1.00 Litre

HG Plastic protector

The liquid polymer emulsion of this unique product forms a wafer-thin, yet extremely strong protective film with a shine after drying. This protects plastic floors, such as vinyl, linoleum, marmoleum, PVC and cast floors, against wear, scratches and other damage. This protective film for plastic floors also masks existing signs of wear and also provides an anti-slip effect. 1 litre is good for approximately 40m2 per layer.

Ingredients
Contains, among other things: preservatives: Benzisothiazolinone

Use
Follow the steps below for the correct use of HG plastic protector (product 77). 1. Make sure the surface is completely clean, free of grease and dust. 2. Do not shake the product before use. Spread HG plastic protector undiluted in one direction over the floor using a wax applicator. 3. Allow it to dry for 60 minutes. 4. If necessary, apply a second layer perpendicular to the first layer. 5. The floor is walkable again approximately 1 to 2 hours after the last treatment. It is fully cured after 3 days.

Warnings
Transport and store bottle upright. Store frost-free. If this product is used on a floor with a click system, first check whether the intermediate layer is made of 100% plastic. If this is not the case, do not use this product, as the intermediate layer may then swell. Do not use in areas where it may be damp, such as bathrooms. EUH208- Contains Triisobutyl phosphate. May cause an allergic reaction. P101- If medical advice is needed, have product container or label at hand. P102- Keep out of reach of children.

Manufacturer / Distributor
HG International BV